The Enduro is a classic design with our high grade electronics inside.  It's one of the most powerful vape pens on the market and can be used with both 510 threaded cartridges or the Ario Vape Wax Stick or Pocket Puff concentrate attachments.

Instructions for Enduro 1100mAh battery

For optimal performance, fully charge before first use.

Charging: Plug the included micro usb cord into the slot at the end of the pen.  Charge the battery with a wall charger (not in your car or with a computer) *never use a fast charger*.  Always use a wall charger with a power output of 2A or less. When it is charging, the power light will be red.  When it is fully charged, the red light will turn off.

To use: Screw your favorite oil cartridge or concentrate attachment onto the threaded end of the pen.  Turn the pen on by clicking the button 5 times quickly. The light ring will flash when the device turns on or off. Press and hold the button (the light ring around the button will illuminate to indicate it is on) and inhale on your cartridge. 

Power on or off: Click the button 5 times quickly (5 times within 3 seconds).

Change power level: The Enduro has 3 power settings to maximize your vaping experience.  To change the power, click the button 3 times.  The light will flash, indicating the power level.

Blue = Low
Green = Medium
Red = High

Please note that you can use any power setting for most 510 threaded cartridges, but the pen should be set to High when using concentrate attachments like the Pocket Puff or Wax Stick.

Troubleshooting:

Product tastes burnt - Change to a lower power setting. 

Cartridge isn't working - Unscrew your cartridge and check to see if it or the pen need to be cleaned of residual oil (visually inspect where the two connect).  To clean residual oil, power off the pen and then moisten the end of a cotton swab in isopropyl alcohol. Wipe down both the bottom of the cartridge and the contact pin (where the pen connects to the cartridge).  Let the pen and cartridge air dry.  Once dry, reinstall cartridge.

Light won't turn on when button is pressed - Press button 5 times quickly (5 times within 3 seconds)

Pen won't turn on when button is pressed 5 times - These are exceptionally reliable batteries, but the cadence of how quickly or slowly you press the button will determine if it will turn on or off.  We recommend slowing your cadence down or speeding it up.  You can also try clicking the button 6 times, as the system doesn't always pick up each click.

Pen won't work after charging - The pen turns itself off when you plug it in.  you will need to turn it on again after you charge it.

Light ring flashes white - This indicates that you have a short circuit in your cartridge or attachment.  Remove the cartridge or attachment and press the button.  The ring light should illuminate according to your power setting.